Attaching The Supplied Carrying Handle (Vt695, Vt595, Vt590 And Vt490 Only) - NEC VT695 User Manual

Bottom
Rear Foot (Left / Right)
( page 23)
Adjustable Tilt Foot
( page 23)
Adjustable Tilt Foot Button
( page 23)

Attaching the supplied carrying handle (VT695, VT595, VT590 and VT490 only)

You can carry the projector by attaching the supplied carrying handle securely to the projector.
To attach the supplied carrying handle, use a Phillips-head screwdriver and the supplied two screws.
Place a soft cloth on the working surface before turning the projector over to prevent scratching the top cover.
Make sure that the carrying handle is attached with correct orientation as shown below.
Carrying handle
CAUTION
When carrying the projector by the carrying handle, make sure the two screws that attach the carrying handle
to the projector cabinet are tight.
Screw
Phillips-head screwdriver
(not supplied)
4
1. Introduction
Lamp Cover
( page 52)