Note On Startup Screen (Menu Language Select Screen) - NEC NP60 User Manual

Note on Startup screen (Menu Language Select screen)

When you fi rst turn on the projector, you will get the Startup menu. The menu gives you the opportunity to select
the menu in one of the nine languages.
To select a menu language, follow these steps:
1. Use the SELECT ▲ or ▼ button to select one of the
nine languages from the menu.
2. Press the ENTER button to execute the selection.
After this has been done, you can proceed to the menu op-
eration.
If you want, you can select the menu language later. (→ [Lan-
guage] on page 41)
NOTE: Immediately after turning on the projector, screen fl icker may occur. This is normal. Wait 3 to 5 minutes until the lamp
lighting is stabilized.
When the [Lamp mode] is set to [Eco], the LAMP indicator will light green.
If one of the following things happens, the projector will not turn on.
• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this
condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's in-
ternal components to cool down.
• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
• If the lamp fails to light, and if the STATUS indicator fl ashes on and off in a cycle of six times, wait a full minute
and then turn on the power.
3. Projecting an Image (Basic Operation)
LAMP
STATUS
AUTO
ADJ.
POWER
FOCUS
ON/STAND BY
LAMP
STATUS
AUTO
ADJ.
POWER
FOCUS
ON/STAND BY
17
OFF
POWER
FOCUS PIC-MUTE
SELECT
SOURCE
MENU
ENTER
OFF
POWER
FOCUS PIC-MUTE
SELECT
SOURCE
MENU
ENTER
ON
PAGE
UP
DOWN
EXIT
ON
PAGE
UP
DOWN
EXIT