Description Of Parts; Instructions For The Power Supply Cord - Gaggia New Espresso 06 Dose Manual

Description of parts:

FIG. 01
1
Main switch
2
Manual dispensing / hot water button
3
Steam button
4 Dose programming/Coffee dispensing button
5
Correct temperature light
6 Turbo frother steam nozzle (removeable)
7
Filterholder
8 1 cup filter
9 Filter for pods
10 2 cup filter
11 Basin (removable)
12 "Perfect cream" Filter (OPTION)
13 Brewing head
14 Filterholder gasket
15 Overflowing protection hole
16 Shower disc
17 Tamper
18 Power cable and plug
19 Measuring spoon
20 Delivery spout
21 Tank cover
22 Grid (removable)
23 Cappuccino maker kit (OPTION)
24 Steam/hot water knob
25 Removable water tank
Instructions for the power supply
cord
A A short power-supply cord is provided to reduce risks of
getting tangled up or tripping over a longer cord.
B Longer extension cords are available and may be used if
care is exercised in their use.
C If a long extension cord is used:
1 the marked electrical rating of the extension cord
should be at least as great as the electrical rating of
the appliance.
2 if the appliance is of the grounded type, the extension
cord should be a grounding type
3 the cable does not hang from the table to avoid the
risk of getting caught up in it.
Preparation:
1. Remove the water tank cover (21) and fill the tank with
cold water checking the level through the tank window
shown in FIG. 02.
N.B.: The upper section of the tank (25) is provided with an
overflowing safety hole (15) in case of tank overfilling.
The water tank can also be removed (FIG.02), after
removing the tank cover (21).
Re-install tank with water and cover.
2. Insert plug (18) into a suitable wall outlet (see point 1
under "Caution").
3. Push the main switch (1). The temperature light (5)
will flash until the temperature is reached; when the
temperature is reached the light will remain on.
Starting up
This procedure fills the water boiler with fresh water.
This should be done whenever the machine is switched on.
This machine, featuring a pump to brew coffee, is equipped
with a self-priming system.
Place an empty cup under the brewing head (13), do not
insert the filter holder and press the hot water/coffee switch
(2) ("1 Pos.).
You will hear the sound of the operating pump, and after
a few seconds, water will start flowing out of the brewing
head (13).
When the cup is filled press the hot water supply button (2)
again.
The Gaggia machine is now ready to be used.
Warning! Before removing the water tank,
make sure that the machine is off as not to
damage the self-primer.
•  •
ENGLISH