Technical Information - Zanussi ZFU27401WA User Manual

Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
1. Remove the plinth.
2. Unscrew and re-
move the lower hing-
es.
3. Remove the door.

Technical information

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
www.zanussi.com
2
1
4. Unscrew the upper
pin and screw it on
the opposite side.
5. Refit the door.
6. Make sure the
edge of the door is
parallel with the edge
of the top.
Height
Width
Depth
A
B
7. Unscrew the pin
(A) and screw it on
the opposite side.
8. Remove the cap
(B) and position it on
the opposite side.
9. Screw the lower
hinges.
10. Refit the plinth.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of the
gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
1850 mm
595 mm
658 mm
20 h
230 - 240 V
50 Hz
11. Stand the appli-
ance upright.
12. Fit the handle on
the opposite side and
put the plastic caps
(contained in the in-
structions bag) in the
free holes.
23