Maintenance And Service - Bosch pts 10 Original Instructions Manual

OBJ_BUCH-783-003.book Page 50 Thursday, November 19, 2009 4:24 PM
50 | English
Adjusting the Insert Plate (see figure N)
Checking:
The front side of the insert plate 3 must be flush
with or somewhat lower than the saw table; the
rear side must be flush with or somewhat above
the saw table.
Adjusting:
– Adjust the correct level with help of the four
adjusting screws 66.
Storage and Transport (see figure O)
Storing the Power Tool
For storage purposes, the hold-down stick,
stops/guides and spare saw blades can be se-
curely fastened to the power tool.
– Lock the yellow safety flap 30 and the locking
lever 24 of the sliding table 1.
– Bring the machine into the transport posi-
tion. (see "Transport Position", page 46)
– Loosen the auxiliary parallel fence 18 from
the parallel fence 8 or from the angle stop 16.
– Position the stops/fences (8, 16, 18) and fas-
ten the hold-down stick 22.
– Wind the mains cable around the cable hold-
er 31.
– A spare saw blade can be fastened to the ma-
chine housing for storage with help of the
fastening screw 19.
Carrying the Power Tool
The power tool should always be carried by
two persons in order to avoid back injuries.
When transporting the power tool, only use
the transport fixtures. Never carry the pow-
er tool by the protective devices, the table
extension 2 or the table width enlargement
9.
– For lifting or transporting, hold the power
tool by the recessed grips 67 on the side of
the saw table 11.
1 609 929 T49 | (19.11.09)

Maintenance and Service

Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Accessories
Base unit . . . . . . . . . . . . . . . . . . 2 607 001 967
Saw blades for wood and plate materials,
panels and strips/mouldings
Saw blade 254 x 30 mm,
40 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 443
Saw blade 254 x 30 mm,
60 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 444
After-sales Service and Customer As-
sistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Bosch Power Tools