Turn On The Wt11 And Play - Yamaha wx11 Product Manual

Turn ON the WT11 and Play

1. Turn ON the rear-panel POWER switch. For a few seconds
after the POWER switch is turned ON, all the panel LEDs
will light and " * YAMAHA WT11 * " will appear on the
LCD display panel. After this, the mode that was active
when the power was last turned OFF will be automatically
re-selected and the WT11 is ready for operation.
2. If an LED indicator other than the PLAY LED is lit, press
the PLAY button to enter the play mode. At this point you
should be able to play the WX11 and produce some sound —
assuming that your system is properly set up as described
above. If nothing happens, check all connections and con-
trols again (Is your sound system turned ON? Is the volume
control turned up? Is the WT11 INPUT SELECT switch set
to WX IN?).
3. To select and try out the many performance combinations
provided by the WT11, use the BANK button to select any
of the available memory banks (A, B, C or I), and then use
the DATA ENTRY +1 and -1 buttons to select any of the 32
performance combinations contained in each bank.
Note:
Do not apply breath pressure to the WX11 when turning
the system power ON, and do not press the setup key
while playing.
Note:
Although the bare essentials of WT11 operation are de-
scribed here, the WT11 offers a wide range of features
and you should most definitely read the WT11 Opera-
tion Manual thoroughly in order to make full use of its
performance potential.
Performance Combination
1 — 3 2 ?
5