Cleaning & Maintenance; Specifications - Yamaha wx11 Product Manual

Since the WX11 is basically an electronic instrument, it does
not require the constant cleaning and maintenance that acoustic
wind instruments do — no oil, no changing of valve pads, etc.
On the contrary, unnecessary dismantling of the instrument can
cause serious damage and will void the warranty.
The interior of the instrument is designed to be highly resistant
to the effects of saliva and condensation, and can be placed on
its side after use with no fear of damage.
After a long period of use, however, you will no doubt want to
clean the mouthpiece and reed. This can be accomplished as
follows:
When cleaning the mouthpiece, remove it completely from
the WX11 body (it simply pulls out), and remove the reed by
loosening the two screws which attach it to the mouthpiece.
The mouthpiece and reed can now be wiped clean with a soft
cloth, or washed with a light solution of a neutral detergent
and warm (not hot) water.
Sensors
Keys/Switches
Trim Control
Terminal
MIDI Transmit Channel Channel l only
* Speifications and appearance subject to change without notice.
CLEANING & MAINTENANCE

SPECIFICATIONS

Wind Sensor, Lip Sensor
14 key switches. Octave keys
(-2, -1, +1, +2 +3), Setup key,
Hold key, Program Change
key
LIP ZERO
Special format
(DC IN + MIDI OUT)
The mechanism inside the mouthpiece — the lip sensor can-
tilever and the rubber housing — should be wiped clean with
a soft cloth. Do not wash this area. Be very careful not to
bend or apply excessive force to she cantilever while doing
this. Also make sure that no water or other fluids get into the
breath sensor aperture or the area around the rubber housing.
The mouthpiece can be reinserted into the WX11 body after
reattaching the reed. The reed screws should be rotated only
until they seat firmly. A little wind-instrument grease can be
applied to the outer edge of the rubber housing to ensure a
smooth, easy fit.
The WX11 body and keys should be cleaned only with a
soft, dry cloth.
Power Supply
Dimensions (L x W x D)
Weight
Accessories
Power received from WT11
via dedicated connecting cable,
or from optional BT7 MIDI/
Power Pack if WT11 not used.
596.5 x 65 x 69.4 mm
(23-1/2" x 2-1/2" x 2-3/4")
420 g (15 oz)
Soft Case
Cable
Polishing Cloth
Strap
15