Currys Essentials cdwtt11 Installation Instructions Manual page 9

INSTALLATION
8. Make sure your plumbing is suitable for use with
the dishwasher. If in doubt contact a qualified
plumber. This unit MUST BE connected to COLD
WATER MAINS using the new water inlet hose.
OLD HOSE SETS MUST NOT BE RE-USED. The
water pressure from the water mains needs to
be at a minimum of 0.04 MPa and a maximum of
1.00MPa.
• Connect one end of the safety water supply
hose to your dishwasher, and then connect
the other end of the hose to your water
mains. Please ensure the black rubber seal is
in place.
• After connecting the hose, turn on your water
mains and check for leaks.
• Connect the dishwasher to the mains socket.
You may use a Y-adaptor (not included)
for an additional water feed for another appliance, for example a
washing machine. This is only applicable for cold water mains. A
Y-adaptor is available from most DIY stores.
• Do not bend your drain hose.
• Do not lift the drain hose higher than 10 cm
from the table top, otherwise the unit may
not be able to expel the waste water properly.
• Secure the water drain hose to the waste pipe
to avoid it coming off during the washing
process.
• The waste pipe must only be connected
to the foul drains and not the surface
water drainage system.
• The water drain hose should be placed
lower than 10cm from the table top
and must not be extended, otherwise
the unit may not be able to expel the
waste water properly.
• You may use the u-shaped drain hose
holder to secure your drain hose and to
avoid bending it.
• Please close the hydrant after use.
water mains
Y-Adaptor
(not included)
Connect to
another
appliance
if required.
water supply hose
max.
10cm
9