Important Safeguards; Installation - NEC MultiSync MT600 User Manual

Operation of this equpment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interfer-
ence at thier own expense.
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus as set out in the Radio Interference
Regulations of the Canadian Department of Communications.

Important Safeguards

These safety instructions are to ensure the long life of your LCD projector
and to prevent fire and shock. Please read them carefully and heed all
warnings.

Installation

1. For the best results, use the LCD projector in a darkened room.
2. Place the LCD projector on a flat, level surface and in a dry area free from
dust and moisture.
14 D Down
15 D Right
16 D Left
17 X2/X4
18 Freeze
19 Front Floor
20 Front Ceiling
21 Rear Floor
22 Rear Ceiling
23 Auto Start On
24 Auto Start Off
25 Auto Picture On
26 Auto Picture Off
27 Highcontrast On
28 Highcontrast Off
29 Power MGT On
30 Power MGT Off
31 800x600 Mode
32 640x480 Mode
85H No Same as remote
5EH No Same as remote
5FH No Same as remote
87H No Same as remote
91H No Same as remote
15H No
16H No
17H No
18H No
19H No
1AH No
1BH No
1CH No
1DH No
1EH No
23H No
24H No
25H No
26H No
3. Do not place the LCD projector in direct sunlight, near heaters or heat
radiating appliances.
4. Exposure to direct sunlight, smoke or steam could harm internal compo-
nents.
5. Handle your LCD projector carefully. Dropping or jarring your projector
could damage internal components.
6. Do not place heavy objects on top of the LCD projector.
7. If installing the LCD projector on the ceiling:
a. The ceiling must be strong enough to support the LCD and the
installation must in accordance with any local building codes.
b. The LCD projector must be installed by qualified NEC service
personnel.
3
SPECIFICATIONS
60