Basic Operation - NEC LT150 User Manual

Basic Operation

Selecting the computer or video source
SOURCE
Each time the Source button is pressed, the input source will change
as follows:
RGB Video S-Video
If no input signal is present, the input will be skipped.
Optimizing RGB image automatically
Press the Auto Adjust button to optimize an RGB image automati-
cally.
SOURCE
Press the Auto Adjust button to fine-tune the computer image or to
remove any vertical banding that might appear and to reduce video
noise, dot interference or cross talk (this is evident when part of your
image appears to be shimmering). This function adjusts the clock
frequencies that eliminate the horizontal banding in the image. This
function also adjusts the clock phase to reduce video noise, dot inter-
ference or cross talk. (This is evident when part of your image ap-
pears to be shimmering.)
This adjustment may be necessary when you connect your computer
for the first time.
NOTE: The Auto Adjust function does not work for component signal.
AUTO
ADJ.
PC Card Viewer
Source display
AUTO
ADJ.
Volume control
Sound level from the speaker on the projector can be adjusted.
NOTE: When the menu or the pointer appears, you cannot adjust the volume.
increase volume
Vol.
SELECT
Vol.
decrease volume
Turning off picture and sound
Press the Picture Mute button to turn off the image and sound for a
short period of time. Press again to restore the image and sound.
Getting Help about how to operate the projector
You get the contents about Help.
HELP
Display Help
E–30
Volume bar
PIC.
MUTE
Vol.
SELECT
Vol.
Exit Help