Table of Contents
Advertisement
Remote Control Battery Installation
NOTE: Remove the transparent insulation tape by pulling it before use.
1
Push the catch to the right and remove the battery holder.
Catch
Battery holder
2
For the first use:
1. Remove the transparent insulation tape.
2. Place the Lithium coin cell on the battery holder. Ensure
that the side with the mark "+" is up.
For battery change
Remove the old Lithium coin cell and install new one
(CR2025).
Ensure that the side with the mark "+" is up.
3
Push the battery holder back into the remote control until
you feel a click.
Transparent in-
sulation tape
Transparent insulation tape
E–13
Operating Range
The infrared signal operates by line-of-sight up to a distance of ap-
proximately 22 feet (7m) and within a 60-degree angle of the remote
sensor. The projector will not function if there are objects between
the remote control and the remote sensor on the projector or if strong
light falls on the remote sensor. A weak battery will also prevent the
projector from operating
7m
30˚
30˚
This sample may be slightly different from actual range
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Do not place the battery upside down.
• Keep the coin cell battery out of reach of children so as not to
allow them to swallow the cell battery.
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer.
Dispose of used batteries according to your local regula-
tions.
7m
30˚
30˚
Advertisement
Table of Contents
