Electrical Requirements; Parts And Features; Turntable - KitchenAid KMBS104 Use & Care Manual

Built-in microwave oven
Hide thumbs Also See for KMBS104:
Table of Contents

Advertisement

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
A 120-volt, 60 Hz, AC-only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
I
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven. A short power supply
cord is provided to reduce the risks resulting from becoming
entangled in or tripping over a longer cord.
SAVE THESE INSTRUCTIONS

PARTS AND FEATURES

This manual may cover several different models. The model you
have purchased may have some or all of the features shown
here. The appearance of your particular model may differ slightly
from the illustrations in this manual.
A
B
L
K
J
I
A. Trim
B. Control panel
C. Door lock system
D. Model and serial number plate
E. Glass turntable
F. Turntable support, rollers,
and hub

Turntable

A
B
C
A. Turntable
B. Support
C. Hub
The turntable can rotate in either direction to help cook food
more evenly. For best cooking results, do not operate the
microwave oven without having the turntable in place. See the
"Assistance or Service" section to reorder any of the parts.
To Install:
1. Place the support on the microwave oven cavity bottom.
2. Place the turntable on the support.
Fit the raised, curved wedges in the center of the turntable
bottom between the 3 spokes of the hub. The rollers on the
support should fit inside the turntable bottom ridge.
C
D
E
F
H
G
G. Door handle
H. Window
I. Cooking guide label
J. Frame
K. Microwave oven light
(inaccessible – in ceiling)
L. Microwave inlet cover
5

Advertisement

Table of Contents
loading

Table of Contents