Connecting To A Single Workstation; Ferrite Core Installation - NEC GT1150 User Manual

Connecting to a Single Workstation

You can connect a workstation to your GT1150 projector. To do so:
1. Turn off the power to your projector and workstation.
2. Use a BNC x 5 cable to connect your workstation and the RGB 1 connectors on your projector.
3. Turn on the projector and a workstation.
To RGBHV output
To analog
RGB input
Workstation
NOTE: All cables mentioned above are sold separately.
Information for Reducing Radiation of Electromagnetic Waves
To reduce unnecessary radiation of electromagnetic waves, use the supplied ferrite core,
Installation Instructions
1. Open and attach the ferrite core to a sig-
nal cable as close as possible to the end
that goes to the projector.
* Push the catch to open the ferrite core.
2. Close the ferrite core tightly.
To RGBHV output
Signal distribution
To RGBHV input
To analog RGB output
3. Fix the supplied band to the cable as a stopper.
* Pull the end of the band to tighten it. Cut off the surplus of the band.
NOTE: Be sure to use the ferrite core at the end of the signal cable.
To RGB2 input of GT1150
E – 27
DVI L/MONO
L/MONO
MONITOR OUT RGB 2
RGB 1 R/Cr G/Y
VIDEO 1 H/HV
L/MONO R L/MONO R
VIDEO 2
L/MONO R L/MONO
S - VIDEO AUDIO OUT
Band
To a connected equipment
BNC 5 cable
R
R
B/Cb
V
R