Advertisement
Check Before First Flight
Move the throttle stick to the lowest position and switch on power of transmitter, connect
battery to the 500X and do not move/shake it until the motor come up with 6 acknowledging
tones (♪-♪-♪---♪-♪---♪), now it is ready for flight.
2S Lipo
先將發射機開關打開(油門THRO置於最低點), 500X的電源接上後不要搖晃機體, 等馬達發出
登-登-登---登-登(代表2S電池)---登 6個音後便可開始操作.
Check the operating direction of each motor and propeller on the ground first to make sure the
500X is able to be controlled correctly by the transmitter. Set the transmitter functions properly
if it did not come with correct response (figure shown is the "THOR" control stick of "MODE 1"
transmitter).
剛開始先不要將500X離地(在地上滑行),先測試螺旋槳轉動方向對不對,再來測試前後,轉彎及左右方向對不
對,若有方向相反,請由遙控器做指令反向調整.(圖示為 Mode 1 遙控器)
MODE 1
Check Before First Flight
Move the "ELE" stick a little bit upward to check and make sure the 500X tilts forward as
shown in figure below (figure below indicates the "ELE" control stick of "MODE 1" transmitter).
*向前指令
Move the "RUD" stick rightward to check and make sure the 500X rotates(turn right) as shown
in figure below (figure below indicates the "RUD" control stick of "MODE 1" transmitter).
*右轉指令
試飛
試飛
MODE 1
MODE 1
P.14
G A UI
T AI SHIH HOBB Y CORPOR A TION
G A UI
T AI SHIH HOBB Y CORPOR A TION
Advertisement
