Advertisement
3.4 RESETTING THE SYSTEM
To reset the panel enter your user code. The speaker will emit a low level two tone
alternating ( Dee dah ) sound to indicate that there is a "RESET REQUIRED". Press the # key to reset the
panel. If the reset is allowed an accept tone will be given the LEDs for the zones in alarm will go out and
the panel will return to the 'DAY' mode. If the reset is not allowed an error tone will be given, the LEDs will
still indicate the alarm state. Call your alarm company to complete the reset. You will not be able to set
your system again until a reset has been completed.
NOTE. If an internal speaker is not fitted in your control panel then the tones given are limited and may not
relate to the above information. Contact your Installer regarding the fitting of a 16 ohm extension speaker.
4.0 USER OPTIONS
4.1 AUTO TEST
Enter your four digi t user code, the speaker will emit a steady sound and the exit time start. Press
the * key followed by the 9 key. The exit tone will stop and all the LEDs will light. After the 10 Second LED
test the internal speaker, bell and strobe will each operate for 5 seconds the control will then emit an
accept tone and revert to the 'DAY' mode. You may end the test at any time by pressing the * key.
4.2 CHANGING THE USER CODE
Enter your four digit user code, the speaker will emit a steady sound and the exit time w ill start.
Press the * key followed by the 9 key, then press the 1 key. 4 LEDs will now come on to indicate a new 4
digit code is required. Enter your new code. As you press each key one LED will go out. If your new code is
allowed an accept tone will be given. If the new code is barred an error tone will be given and your old code
will still be valid. Start again and enter a different four digit code.
As an example we will change user code 1 to 4567. You would enter.
4.3 REVIEWING THE ALARM LOGS
The logs are organised as 'SET' and 'UNSET' events. All events are recorded. The first alarm is
shown by the relevant LED being lit continuously. Subsequent alarms are shown by a fast pulse of the
zone LED. Any zones isolated are shown by a slow pulse of the zone LED. The speaker will sound whilst
viewing the 'SET' logs but will be silent whilst viewing the 'UNSET' logs.
Pressing the # key will change between viewing the 'SET' and 'UNSET' logs. This may be done at
any time. The log review will automatically end after 15 seconds if no keys are pressed.
Enter the four digit user code, the speaker will emit a steady sound and the exit time start. Press
the * key followed by the 9 key, then press the 3 key. The log routine will start viewing 'DAY' 1 'SET'
Press the * key to finish.
You should test your system at regular intervals, to aid this a walk test mode is prov ided. You are
allowed to test all ALARM devices. DO NOT TEST ANY PERSONAL ATTACK BUTTONS.
Enter the four digit user code, the speaker will emit a steady sound and the exit time start. Press
the * key followed by the 9 key, then press the 4 key. The speaker will emit a low level steady tone.
As you test each device the internal sounder will give a loud pulsing tone to indicate the correct operation
of that device. The zone number LED will light. When the device test is over the sounder will stop and the
zone LED will go out. The speaker will emit a low level steady tone as before. Report any faults to your
Installer. Press the * key to finish.
<CODE> * 9 1 4 5 6 7
KEY
VIEW
1
LOG 1
2
LOG 2
3
LOG 3
4
LOG 4
5
LOG 5
6
LOG 6
7
LOG 7
8
LOG 8
9
LOG 9
0
THE LAST ALARM
www.ukpanels.com
Advertisement
