Assembly - Stanley U-Install Owner's Manual

ldler Tube
Assemble Tube Sections
Align Holes on the Side
to Make Assembly
Stronger
To protect the power unit during assembly and installation,
use one of the cardboard panels packed with the unit. Locate
the radio transmitter inside the packing material and set it
aside in a safe place.
A. Assemble the 5 tube sections with the holes alisned on the
side as shown in Fig. 1.
M A K E C E R T A I N T H A T T H E T U B E S E C T I O N S A R E
FULLY SEATED
There may be a small space between tube sections, hou,ever
t h e " E n d T o E n d " a s s e m b l e d l e n g t h m u s t b e 1 1 8 - 1 i 4 " ( o r
less). (You may need to gently tap them together.)
FIG. 3
Tube Support
Insert plug button into end of the tube, (make sure it is
fully seated). See Fig. 2. Attach the pulley to the other end
of the tube using the one and one half inch (l l/2") long
clevis pin and a lock clip. See Fig. 24.
Slide the traveler onto the tube assembly making sure the
arrow on the traveler marked ( |D|o6;>) points towards the
idler assembly.
Insert the end of the tube assembly that has the plug but-
ton, into the tube support on top of the power unit. See
Fis. 3.
B .
C .
D
1-112" Clevis Pin
FlG. 2
Plug Button
Plug Button End of
Tube Assembly
ldler Assembly
Page 6
06E.2