Table of Contents
Advertisement
CONTROLS
Your new garage door opener offers momentary control. To
operate the door simply press either the hand held transmitter
button or the wall mounted pushbutton for one to two seconds
and the door will automatically open or close. The opener can
be stopped during any portion of the opening or closing cycle
by pressing either of the buttons. The next time the button is
pressed, the opener will re-start the door in motion in the
opposite direction.
OBSTRUGTION SENSING
When properly adjusted, the door will automatically reverse if
it senses an obstruction during the closing cycle. This system
will also stop the door if it hits an obstacle when opening.
SAFE.T.CYCLETM
This electronic system will reverse the door in 30 seconds or
less if the door is unable to travel to the full closed position.
This feature provides automatic reversing should other sys-
tems fail to operate and the door does not fully close.
SAFE.T.SIGNALTM
Lights will flash whenever Safety Reverse or Safe-T-Cycle
has been activated.
FORCE ADJUSTMENTS
Independent OPEN and CLOSE dials allow you to select the
minimum required opening and closing force.
EMERGENCY RELEASE
Your door opener is equipped with an emergency release
device. In the event of a power failure, pull the knob on the
pull cord down and slightly to the back (away from door)
allowing the disconnect to latch. This will allow you to man-
ually open or close the door. When power has been restored,
gently pull the disconnect cord, releasing the traveler detent,
then press either the transmitter or pushbutton. The opener
will automatically reconnect.
SAFE.T.MONITORTM
A dynamic obstruction detection device that continuously
monitors the amount of force required to move the garage
door, and automatically adjusts the obstruction detection level
in addition to the homeowner adjustable force levels. This
SAFETY SYSTEM adds the additional level of protection
indicating our commitment to safe garage door operation.
CONTROL CONNECTIONS
All opener models are provided with screw terminals for the
attachment of a wall mounted pushbutton or four-function
wall console. The console includes a pushbutton, worklight
switch, vacation switch, and pedestrian light. Some models
are provided with a pushbutton only, but ALL MODELS can
be connected to the four-function wall console which is sold
separately.
Voltage Required:
120 Volts a.c.
60 cycle
Single Phase
A grounded, three (3) hole electrical outlet is required.
Motor Specs:
Permanent Split Capacitor -Internal
Automatic Over load Reset
Current Required:
7 AMPS
Overload Protection:
The motor is equipped with an auto-
matic thermal over load device. Should the motor become
over heated, the over load device will render the opener inop-
erative. Simply wait approximately 5 to 10 minutes for the
motor to cool.
Opener Length:
Minimum Head
Room Required:
Average Door Speed:
Maximum Door Size:
1 0 F e e t - 8 I n c h e s
From end of tube assembly to
rear of opener power unit.
2 Inches (Tracked Doors)
6 Inches (Trackless Doors)
6 Inches per second
L / 4 H } . :
16 Ft. Wide / 7 Ft. High
1 / 3 H . P . o r I / 2 H P . :
18 Ft. Wide l7 ll2Ft.High
03c.1
Page 3
Hide quick links:
Advertisement
Table of Contents
