Remote recording
You can set timer programming events of this TV on the network equipment
(smartphone, etc.) from outside the home network.
Ensure the network connections and network settings are completed.
●
Network > Network connections
Network > Network settings
Set
TV Anywhere
●
Network > Network settings > TV Anywhere Settings
Additional information for the services may be found on the following
●
website.
http://panasonic.net/viera/support (English only)
= Note =
This function is not available when the TV is turned off with Mains Power
●
On / Off switch.
Depending on the network condition, this function may not be available.
●
Note
TV Guide
may also be used to set timer event.
●
Watching > TV Guide > Timer Programming
Timer Programming
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
For recording using
●
Standby. For reminders to be displayed, the TV must be on.
No other channels can be selected while the recording of
●
Programming
is in progress.
Recording an encrypted (copy-protected) programme may not be possible.
●
2 minutes before the start time, a reminder message appears if you are
●
watching TV.
– To remove the message and start the programming, press OK.
– To cancel the programming, press EXIT.
LED will turn to orange in Standby mode if
●
Reminder messages will remain displayed until one of the following
●
occurs:
– You press
OK
– The timer event that the reminder is set for ends.
to On.
can store up to 15 events.
only works reliably if correct time information is
Timer
Programming, the TV must be either on or in
to view the programme or
- 91 -
Timer
Timer Programming
EXIT
to cancel the reminder.
is set.