Suunto Memory Belt User Manual page 14

If the memory is full, measuring ends and the device switches to sleep mode. This is indi-
cated by 2 long beeps and 2 long, orange flashes. This signal continues until you take off the
belt. You should then download your data to your PC and must empty the belt's memory
before you can continue to use your Suunto Memory Belt to record heart rate data.
NO HEART RATE DETECTION
If, during recording, Suunto Memory Belt no longer detects your heart rate, it will alert you by
2 long beeps and 2 long, green flashes every 30 seconds. As long as there is available mem-
ory, the device will continue to give this warning every 30 seconds while in contact with the
skin. If the belt detects your heart rate again, it will give a medium-length beep and a
medium-length, green flash. If you take the belt off, it will stop recording and go into sleep
mode after 60 seconds. This is indicated by 3 short beeps and 3 short, green flashes.
12
2 long, orange
2 long
memory full, switching to sleep
mode