Pride JAZZY GO 2 Owner's Manual
  1. Manuals
  2. Brands
  3. Pride Manuals
  4. Wheelchair
  5. JAZZY GO 2
  6. Owner's manual
Pride JAZZY GO 2 Owner's Manual

Pride JAZZY GO 2 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
JAZZY GO 2
32 Wedgwood Road • Bicester, Oxon OX26 4UL

Advertisement

Table of Contents
loading

Related Manuals for Pride JAZZY GO 2

Summary of Contents for Pride JAZZY GO 2

  • Page 1 JAZZY GO 2 32 Wedgwood Road • Bicester, Oxon OX26 4UL...
  • Page 2 S A F E T Y G U I D E L I N E S WARNING! An authorised Pride Dealer or a qualified technician must perform the initial setup of this power chair and must perform all of the procedures in this manual.

  • Page 3: Table Of Contents

    SAFETY ..............................5 III. YOUR POWER CHAIR ........................17 IV. ASSEMBLY............................20 COMFORT ADJUSTMENTS......................22 VI. BATTERIES AND CHARGING ....................... 26 VII. CARE AND MAINTENANCE ......................30 VIII. WARRANTY............................35 IX. APPENDIX I - SPECIFICATIONS ....................36 Jazzy Go 2 www.pridemobility.com...

  • Page 4: Introduction

    Pride to enhance or preserve the safe use of this product.

  • Page 5: Safety

    Avoid exposure to rain, snow, ice, salt or standing water whenever possible. Maintain and store in a clean and dry condition. Do not use a cell phone, walkie/talkie, laptop or other radio transmitter while operating. Jazzy Go 2 www.pridemobility.com...
  • Page 6 Do not connect an extension lead to the AC/DC converter or the battery charger. Removal of grounding prong can create electrical hazard. If necessary, properly install an approved 3-pronged adapter to an electrical outlet having 2-pronged plug access. Wear safety goggles. Corrosive chemicals contained in battery. Contains Lead. www.pridemobility.com Jazzy Go 2...
  • Page 7 Connect Black wire to Black Negative (–) Terminal Post Do not use batteries with different amp-hour (Ah) capacities. Do not mix old and new batteries. Always replace both batteries at the same time. Do not remove anti-tip wheels. Jazzy Go 2 www.pridemobility.com...
  • Page 8 S A F E T Y Battery charger for indoor use only. Disposal and recycling - Contact your authorised Pride Dealer for information on proper disposal and recycling of your Pride product and its packaging. Unlocked and in freewheel mode.

  • Page 9: General Guidelines

    Pride products. Pre-Ride Safety Check Get to know the feel of your power chair and its capabilities. Pride recommends that you perform a safety check before each use to make sure your power chair operates smoothly and safely.
  • Page 10 Your power chair is rated for a maximum weight capacity. Please refer to the specifications table for this limit. MANDATORY! Stay within the specified weight capacity of your power chair. Exceeding the weight capacity voids your warranty. Pride will not be held responsible for injuries and/or property damage resulting from failure to observe weight limitations.
  • Page 11 Doing so could cause instability in your power chair. Pride recommends that the maximum slope of an incline you attempt to safely ascend or descend on your power chair does not exceed 8.7% (5 °). See figure 1.
  • Page 12 Your power chair is designed to provide optimum stability under normal driving conditions—dry, level surfaces composed of concrete, blacktop or tarmac. However, Pride recognises that there will be times when you will encounter other surface types. For this reason, your power chair is designed to perform admirably on packed soil, grass and gravel. Feel free to use your power chair safely on lawns and in park areas.
  • Page 13 Motor Vehicle Transport Pride recommends that you do not remain seated in your power chair while traveling in a motor vehicle. The power chair should be stowed in the boot of a car or in the back of a truck or van with batteries removed and properly secured.
  • Page 14 Never reach, lean or bend while driving your power chair. If it is absolutely necessary to reach, lean or bend while seated on your power chair, it is important to maintain a stable centre of gravity and keep the power chair from tipping. Pride recommends that the power chair user determine his/her personal limitations and practice bending and reaching in the presence of a qualified healthcare professional.
  • Page 15 Always have an attendant or healthcare profes- sional present while learning to properly transfer yourself. To eliminate the possibility of injury, Pride recommends that you or a trained attendant perform the following tasks before attempt- ing a transfer: ! Turn off the power to the controller.
  • Page 16 WARNING! Pride strongly recommends that you do not smoke cigarettes while seated in your power chair, although the power chair has passed the necessary testing requirements for cigarette smoking.

  • Page 17: Your Power Chair

    THE JAZZY GO 2 The Jazzy Go 2 has two main assemblies: the seat assembly and the power base assembly. See figure 5. Typically, the seat assembly includes the armrests, seatback and seat base. The power base assembly includes the two motors, two drive wheels, two castor wheels, two anti-tip wheels, two batteries and a foot platform.
  • Page 18 LEVERS CIRCUIT BREAKER Figure 6. The Jazzy Go 2 Power Base Electrical Components The electrical components are located on the power base. The main circuit breaker is located toward the rear of the power base. The controller and charger connectors are located on the rear of the power base. See figure 6.
  • Page 19 To clear this code, turn off the controller and place the power chair in drive mode. Then turn on the controller. The error message should be cleared. If not, contact an authorised Pride Dealer. To engage or disengage the drive system: 1.

  • Page 20: Assembly

    Replacement nylon insert lock nuts are available at local hardware stores or through your authorised Pride Dealer. ARMREST WIDTH ADJUSTMENT SEAT INSTALLATION BATTERY COVER SEAT HEIGHT ADJUSTMENT CONTROLLER POSITION BATTERIES FOOT PLATFORM DEPTH ADJUSTMENT Figure 8. Jazzy Go 2 Assembly View www.pridemobility.com Jazzy Go 2...
  • Page 21 5. Plug the controller and off-board charger port cables into the connectors on the power base. See figures 6 and 9. Jazzy Go 2 www.pridemobility.com...

  • Page 22: Comfort Adjustments

    Use the steps below to make comfort adjustments. WARNING! If your power chair was configured by an authorised Pride Dealer, please consult the authorised Pride Dealer before changing the seat position or making any other adjustment. Some adjustments may degrade your power chair’s performance and safety by changing its centre of gravity.
  • Page 23 SETSCREW 2. Raise or lower the armrest to the desired height. 3. Tighten the setscrews to secure the armrest. LOCKING NUT ARMREST ANGLE ADJUSTMENT SCREW ARMREST HEIGHT ADJUSTMENT SETSCREWS Figure 13. Armrest Angle and Height Adjustment Jazzy Go 2 www.pridemobility.com...
  • Page 24 To adjust the foot platform depth: 1. Remove the hardware from the foot platform bracket. See figure 14. 2. Move the foot platform in or out to the desired depth. 3. Reinstall the hardware into the foot platform bracket and tighten. www.pridemobility.com Jazzy Go 2...
  • Page 25 MANDATORY! Inspect the positioning belt for loose or damaged parts before each use of the power chair. If you discover a problem, contact your authorised Pride Dealer for maintenance and repair. Jazzy Go 2 www.pridemobility.com...

  • Page 26: Batteries And Charging

    PROHIBITED! Do not allow unsupervised children to play near the power chair while the batteries are charging. Pride recommends that you do not charge the batteries while the power chair is occupied.
  • Page 27 See figure 16. 4. Plug the off-board charger into the electrical outlet. See figure NOTE: If it is a Pride off-board charger, then there are two LEDs in it. Refer to the supplied charger manual for infor- mation on LED indications.
  • Page 28 AGM and Gel-Cell batteries are designed for application in power chairs and other mobility vehicles, allowing safe trans- portation on aircraft, buses and trains, as there is no danger of spillage or leakage. We suggest you contact the carrier’s ticket counter in advance to determine that carrier’s specific requirements. www.pridemobility.com Jazzy Go 2...
  • Page 29 We work closely with our battery manufacturer to provide a battery that best suits your power chair’s specific demands. Fresh batteries arrive regularly at Pride and are promptly shipped with a full charge. During shipping, the batteries encoun- ter temperature extremes that may influence initial performance. Heat robs the charge from the battery and cold slows the power available and extends the time needed to recharge the battery (just as with a car battery).

  • Page 30: Care And Maintenance

    M A I N T E N A N C E CARE AND MAINTENANCE Your Jazzy Go 2 is a sophisticated power chair. Like any motorised vehicle, it requires routine maintenance checks. You can perform some of these checks, but others require assistance from an authorised Pride Dealer. Preventive maintenance is very important.
  • Page 31 Pride Dealer if there is a problem. ! Check for flat spots on solid tyres. Flat spots could adversely affect stability. ! Inspect the armrests for loose hardware, stress points, or damage. See your authorised Pride Dealer if there is a problem. Weekly Checks ! Disconnect and inspect the controller from the power base.
  • Page 32 Your power chair must be disposed of according to applicable local and national statutory regulations. Contact your local waste disposal agency or authorised Pride Dealer for information on proper disposal of power chair packaging, metal frame components, plastic components, electronics and batteries.
  • Page 33 DRIVE WHEEL WASHER 7. Inflate pneumatic wheels to the psi/bar/kPa air pres- sure rating indicated on each tyre. Figure 17. Jazzy Go 2 Drive Wheel 8. Remove the power chair from the blocks. Battery Replacement A battery wiring diagram is printed on a decal located on the front battery tray.
  • Page 34 When to See An Authorised Pride Dealer for Service The following symptoms could indicate a serious problem with your power chair. If necessary, contact an authorised Pride Dealer. When calling, have the model number, serial number, nature of the problem and the error code if available.

  • Page 35: Warranty

    Warranty will also be refused if damage is deemed to have been caused through misuse or accident for which Pride Mobility Products Ltd. cannot be deemed responsible. NOTE: Pride Mobility Products Ltd. provides parts only under warranty. Your authorised Pride Dealer is responsible for labour and service. Please contact your authorised Pride Dealer for information about these services and for any applicable charges.

  • Page 36: Appendix I - Specifications

    Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of (+ or – ) 3%. ³ AGM or Gel-Cell type required. See VI. “Batteries and Charging.” NOTE: All specifications subject to change without notice. www.pridemobility.com Jazzy Go 2...
  • Page 37 S P E C I F I C A T I O N S LENGTH WIDTH 68.58 cm (27 in.) 54.61 cm (21.5 in.) 4.45 cm (1.75 in.) GROUND CLEARANCE TURNING RADIUS Figure 20. Jazzy Go 2 Dimensions and Ground Clearance Jazzy Go 2 www.pridemobility.com...
  • Page 38 N O T E S www.pridemobility.com Jazzy Go 2...
  • Page 39 Inclusion of all Parts Joystick Serial Number Controller Serial Number Left Motor Serial Number Right Motor Serial Number Fit and Finish Performance Pride keeps a more detailed report on file at the factory. Date Inspected Inspector *INFMANU3738* Product Serial #...

Table of Contents