NEC PlasmaSync 42XP10 User Manual page 30

RS-232C
- continued
Th e following control sequence is used for a single monitor
When using the following control commands, all of the daisy-chained monitors
can be controlled at the same time from the primary monitor. However, reply and
status commands will only pertain to the primary monitor, and not to the secondary
monitors.
1) Interface
PROTOCOL
BAUD RATE
DATA LENGTH
PARITY BIT
STOP BIT
FLOW CONTROL
2) Control command diagram
Th e command is structured by the address code, function code, data code and end
code. Th e length of the command is diff erent for each function.
Address Code
HEX 30h 30h
ASCII '0' '0'
[Address code]
[Function code] A code of each fi xed control move.
[Data code]
[End code]
To control multiple monitors that are daisy-
chained together please use the extended control
command.
English-27
RS-232C
9600 [bps]
8 [bits]
NONE
1 [bit]
NONE
Function Code
Function
Function
30h 30h (In ASCII code, 0
'
A code of each fi xed control data (number) and
not always indicated.
0Dh (In ASCII code, ) fi xed.
' '
Data Code End Code
Data 0Dh
Data
0 ) fi xed.
' ' '