Using The Remote - NEC PlasmaSync 42XP10 User Manual

Using the Remote:

Install the remote control batteries.
Th e remote control is powered by AA batteries. To install or
replace batteries:
A. Press and slide to open the cover.
B. Align the batteries according to the (+)
and (–) indications inside the case.
C. Replace the cover.
CAUTION: Incorrect usage of batteries can result in leaks or
bursting. NEC recommends the following battery use:
• Place "AA" size batteries matching the (+) and (-) signs
on each battery to the (+) and (-) signs of the battery
compartment.
• Do not mix battery brands.
• Do not combine new and old batteries, or mix brands.
Th is can shorten battery life or cause liquid leakage of
batteries.
• Remove dead batteries immediately to prevent battery
acid from leaking into the battery compartment.
• Do not touch exposed battery acid, it may injure skin.
• Do not drop or mishandle the remote.
• Do not get the remote control wet. If the remote does get
wet, wipe dry immediately.
• Avoid excessive heat and humidity.
• Do not dispose of batteries in fi re.
• Please follow government regulations or public
environmental rules that apply in your country/area
when disposing of used batteries.
• When replacing, use only conventional non-
rechargeable alkaline or manganese batteries.
• Th ere is a risk of explosion if batteries are replaced
incorrectly.
Operating Range for the Remote Control
Point the top of the remote control toward the monitor's
remote sensor while pressing buttons. Th e remote control
can be used from the front of the monitor at a maximum
distance of 7 m/23 ft . from the front of the Plasma monitor's
remote control sensor. Th e maximum horizontal and vertical
angle for use of the remote is 30 degree within a distance of
3.5 m/11.5 ft .
CAUTION
Th e remote control may not function when direct sunlight
or strong illumination strikes the remote control sensor of
the Plasma monitor, or when there is an object in the path of
the sensor.
Handling the Remote Control
Do not open the remote control other than to install
batteries. Do not allow water or other liquid to splash onto
the remote control. If the remote control gets wet, wipe it dry
immediately.
Avoid exposure to heat and steam.
NOTE: If you do not intend to use the Remote Control for a
long period of time, remove the batteries.
English-8
Installation
- continued
EXIT INPUT MUTE
30
POWER ON STANDBY
PICTURE
RGB DVD/HD VIDEO MEMORY
PICTURE
MODE SIZE
1 2 3
4 5 6
7 8 9
0
DISPLAY MENU
+
SET
AUTO
SET UP EXIT
VOL ZOOM
POINTER
+ +
MUTE
SPLIT SCREEN PIP S BY S SINGLE
SELECT/FREEZE CAPTURE
SWAP
REMOTE ID
SET RESET SLEEP
REMOTE CONTROLLER RU-M113
30