Table of Contents
Advertisement
4. Repeat the above, all 3 LEDS flashing together for the
th
4
remote pairing.
Un- Register The Pairing:
1. Press and hold the Pairing/Test button for 5 seconds to
enter un-register mode, 3 LEDs flash together.
2. If user wants to un-register the 1
Pairing/Test button once, the 1
other 2 LED light), then press and hold the Pairing/Test
button until the 1
st
1
is now un-registered.
3. If user wants to keep the 1
when the 1
nd
the 2
LED flashes (other 2 LED light) to select which to be
un-registered.
4. Repeat the above, all 3 LEDS flashing together for the 4
doorbell unregister.
To check whether the unit works normally, you can press the
Door bell button, the unit would sound alarm and flash.
Operation
Once the main unit and the doorbell have been placed in
the required locations and all required batteries have been
inserted, you are ready to use the device.
To use the device as a doorbell, the person who needs assistance
must press the doorbell button. The indoor unit will sound an
alarm and flash (depending on the Alarm mode setting).
st
LED goes off, beeps to confirm. The
st
LED flashes, press the Pairing/Test button again,
st
doorbell, press the
st
LED will be flashing (the
st
but un-register the 2
11
Installation
nd
rd
or 3
,
th
Advertisement
Table of Contents
