Sending A Signal Tone; Faults And Trouble-Shooting - Swissvoice Babycom 268 User Manual

Babycom 268

Sending a signal tone

Both units can send each other a signal tone:
- Press the PAGE key on the left of the parental/baby unit to call the
other unit.
- A ring tone (3 beeps) is heard on the called unit

Faults and trouble-shooting

Not every malfunction results from a defect in your Babycom 268.
No power
- Unit is switched off. Switch the unit on.
- Check to ensure the batteries are correctly inserted.
- If you are using the adapters for power, check to ensure they are
switched on and correctly connected.
- The batteries are discharged. Charge the batteries or replace them.
Unable to talk to baby unit
- Sensitivity on baby unit too weak. Increase the sensitivity level.
- The units are out of range. Reduce the distance between them.
- Check that the TALK key is not pressed
- Make sure the key block is not activated.
- Check that the parental and baby units are set to the same CTSS
code.
Unable to send signal tone
- Volume on parental unit too weak. Increase the volume.
- Sensitivity on baby unit too weak. Increase the sensitivity level.
- The units are out of range. Reduce the distance between them.
- Check that the TALK key is not pressed
- Make sure the key block is not activated.
56