Control Box - LG LWHD1006R Training Manual

CONTROL BOX

1. Remove the front grille.
2. Remove the cabinet.
3. Remove the 2 screws that
fasten the power cord.
4. Disconnect the ground screw
from the base pan.
5. Remove the screw that secures
the control box cover.
6. Remove the connector between
the PCB and the motor lead.
7. Remove the nut and the terminal
cover from the compressor.
8. Remove the leads from the
OLP. (Overload Protector)
(See page 20.)
9. Discharge the capacitor by
shorting it with a 20kΩ resistor.
10. Lift the control box out of the
way.
11. Reinstallation is the reverse of
these steps.
Refer to the wiring diagram on
page 27of this manual.
LWHD1006R Page 17 of 40 Training Manual