Connecting The Assembly Cable - Samsung MH020FPEA Installation Manual

Connecting the Assembly Cable

The indoor unit is powered from the outdoor unit via the assembly cable.
1 Extend the assembly cable if necessary.
2 Open the front grille by pulling on the tabs on the lower right and left sides
of the indoor unit.
3 Remove the screw securing the connector cover.
4 Pass the assembly cable through the rear of the indoor unit and connect the
assembly cable such as figure.
➢ Each wire is labelled with the corresponding terminal number.
5 Pass the other end of the cable through the 65 mm hole in the wall.
6 Replace the connector cover, carefully tightening the screw.
7 Close the front grille.
8 For further details on how to plug the other end of the assembly cable into
the outdoor unit, refer to installation manual of the outdoor unit.
I
NSTALLING THE INDOOR UNIT
Indoor
1(L) 2(N) F1 F2
unit
1 2 E
F1 F2
Earth
terminal
1 2 E
F1 F2
Outdoor
Earth
unit
terminal
F1 F2
1(L) 2(N)
9
E-