Safety Information; Fcc Notice - Pringo P232 Plus User Manual

Safety Information

Before you use, operate, dissemble the product, or change or remove any parts, components or materials of the product, please ensure
that you carefully read this P232 User's Manual ("Manual") and the safety instructions described below, and strictly follow the instructions
of such safety information.
If there is any question regarding the product and you feel the information provided in the Manual does not provide adequate assistance
in terms of solving the problem you are facing, please contact our customer service staff immediately for professional assistance with
troubleshooting.
For your own safety, HiTi Digital, Inc. ("HiTi") strongly recommends the use of HiTi manufactured and/or designated consumables,
accessories, or peripherals of the product ONLY. HiTi DOES NOT GUARANTEE, implied or expressly, the compatibility of the product with
any non-HiTi made consumables, accessories, or periphrals. Using any non-HiTi made/designated consumables, accessories, or
peripherals which are intended for the product only may damage the product, and/or causes personal injuries and property damages to
the user and/or any third parties.
DO NOT ALLOW MINORS UNDER THE AGE OF 12 TO USE, OPERATE, HANDLE OR STRORE THE PRODUCT AND/OR ITS
BATTERY AND CHARGER PACK.
ALL USE, OPERATION, HANDLING OR STORING OF THE PRODUCT, ITS BATTERY AND CHARGER PACK, AND ANY OTHER
CONSUMABLE OR ACCESSORIES BY ADOLESCENTS ABOVE 12 SHALL BE CARRIED OUT IN THE PROPER PRESENCE AND
CONSTANT SUPERVISION OF FULLY CAPABLE LEGAL GUARDIANS. THE MANUAL AND ALL THE SAFETY INSTRUCTIONS
THEREIN SHALL BE READ TO SUCH ADOLESCENTS PRIOR TO ANY USE, OPERATION, HANDLING OR STORAGE OF
PRODUCT OR ITS BATTERY AND CHARGER PACK.
PLEASE BE ADVISED THAT WE WILL NOT BE RESPONSIBLE FOR ANY INJURIES OR DAMAGES IN PERSON OR PROPERTY IN
ANY FORM, DIRECT OR CONSEQUENTIAL, INCURRED DUE TO USER'S FAILURE TO FOLLOW STRICTLY THE INFORMATION
AND SAFETY INSTRUCTIONS PROVIDED IN THE MANUAL, OR DUE TO ANY USE OF PRODUCT FOR UNINTENDED PURPOSES.
The printer may cease printing for a while when temperature is high.
Notice
Hereby HiTi declares that Pringo P232 is in compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.

FCC Notice

You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment complies with the FCC/IC radiation exposure limits sent forth for uncontrolled equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in Supplement C to OET62 and RSS-102 for the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated with at least 20cm or more between the radiator and person's body (excluding
extremities: hands, wrists, feet, and ankles).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)this device may not cause interference, and
(2)this device must accept any interference, including interference that may cause undesired operation of the device.
1