Table of Contents
Advertisement
Troubleshooting
If a problem occurs with the printer (when LED flashes RED),please always tap
of troubleshooting.
When the problem is solved, send the photo again for printing and follow the steps to remove the error
Problem
Cover open/Ribbon missing
Ribbon out
Paper out
Paper jammed/ribbon jammed
Unable to update firmware
The printer's SSID
is not displayed
on the mobile device
Forget Printer WiFi SSID
and/or password
Low battery
Cooling
Specification
Model name
Printing resolution
Gradation
Photo Format
Print Size
Printing time
Dimension
Weight
Power source
Operation temperature
Operation humidity
Battery pack
Adapter (excluded)
Close the ribbon door or insert a ribbon
1. Change a ribbon
2. Tap 'OK' in App and send the photo to print again.
1. Load paper to the paper tray
2. Tap 'OK' in App and send the photo to print again.
1. Tap 'OK' in App, jammed paper will be ejected automatically.
If jammed paper is not ejected automatically, Please.Turn off the
printer and pull out paper gently
If a gentle tug is not sufficient to remove the paper, please contact
customer support help desk or your distributor. Do not remove jammed
paper/ribbon by force. The printer could be damaged.
Make sure you are using the App "Pringo" to update printer firmware; if the
problem persists, please contact customer service support help desk.
Wait for about 8 seconds after turning on the printer.
Do not use the printer near a device that used 2.4 GHz frequency band
such as a microwave oven or Bluetooth since it will cause radio wave
interference.
Place the printer and mobile device close and do not place any object
between them.
1. Press RESET swtich
about 3 second to reset the printer to factory default settings.
2. Connect to the printer with factory default settings after automatic
reboot.
Be sure to install the battery and power on the printer before reset.
Recharge the battery with the supplied battery charger
Wait for a few seconds the printer to cool down
290 x 290 dpi
256 Gradations
JPEG
2" x 3.4" (54x86mm)
About 60 secs
157 x 99 x 28 mm
About 398g ± 10g
DC 7.4V
15℃ - 32 ℃
20% RH - 90% RH
Voltage 7.4V
Capacity 2600 mAh
Input 100-240V 50/60Hz Max 0.2A
Output 5V 2A
9
Solution
with the tip of an unfolded paper clip for
P232
for instruction
中
Advertisement
Table of Contents
