Operation - Sanyo DC X900 Instruction Manual

OPERATION
THIS TURNTABLE IS DESIGNED FOR USE
ONLY WITH SANYO MODEL
NO. DC X900.
PREPARATION
1. Carefully unpack the unit and other parts. Remove all packing mate-
rial from around the turntable.
2. Locate the unit horizontally on a heavy duty stand or firm level surface,
and away from the speaker system to avoid sound feedback.
3. Connect the output leads and power supply lead to the PHONO
sockets and DC 12V socket of the DC X900 stereo system, The red
plug is for the right channel and the white plug is for the left channel.
CONTROLS
3
1.
2.
3.
4.
5.
6.
7.
2
T
i
1
76
Speed select button (SPEED)
Turntable spindle
45 rpm adapter
Tonearm rest and lock
Headshell with cartridge
Cueing button (CUE)
Reject button (REJECT)
Before you use the turntable, disengage the tonearm lock and carefully
remove the stylus cover.
1.
2.
3.
4.
5.
6.
7.
Press the PHONO function switch on the stereo system.
Place a record disc on the turntable platter. If necessa~, use the
supplied 45 rpm adapter.
Set the SPEED select button for the applicable record speed.
Depress the button for 45 rpm records.
Release it for 33-1/3 rpm LP records.
Depress the CUE button to lift the tonearm from its rest, Gently place
the stylus over the required position on the record. The turntable
platter will begin revolving.
Press the CUE button again to release. The tonearm will gently go
down onto the record.
Adjust the controls on the stereo system for the most pleasant listening
level and tonal balance.
At the end of the record, the tonearm will return to its rest and the
turntable platter will stop revolving.
You may stop the turntable at any time by pressing the REJECT button
which will return the tonearm to its rest.
Do not touch the tonearm or headshell while it is returning to its rest.
Note:
- The first time you use the turntable, the tonearm may not return to its
rest. If this happens, press the REJECT button.
- After use, engage thetonearm lock to avoid accidental stylus damage.
Replacing the stylus
The stylus should have along life if treated carefully. Always clean recor
before use and remove any dust or fluff from the stylus tip with a sman
brush.
Reduced sound quality from a good record means that the stylus may
need replacing. To remove the old stylus, pull out the stylus assembly in
the direction shown, holding the head-shell with other hand. Then install
the new stylus by pushing it gently into the cartridge (hold by edge to
prevent damage to stylus) until it clicks into place.
SPECIFICATIONS
Type:
—
Semi-automatic turntable, with cueing
Motor:
DC motor
Drive system:
Belt drive
Cartridge:
Magnetic
stylus:
Conical with diamond (No. ST-868J)
Wow and flutter:
0.2'% WRMS
Power Supply:
12 V DC supplied from the DC X900
Dimensions (W x D x H):
Approx. 360x 357x 96 mm
Specifications subject to change without notice.
-17-