Quick Start
4. Connect one end of the power cord to the MultiSync
end to the power outlet (Figure D.1).
5. Turn on the monitor (Figure E.1) and the computer.
6. The Factory Setting for your monitor is set for D-SUB installation. If you are using a
BNC cable connection, push the BNC/D-SUB button on the front of the monitor
(Figure E.1) to switch settings.
Figure A.2
R G(/Sync) B
Figure C.1
NOTE: For download information on the Windows
Series monitor, refer to the References section of this user's manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
78134171
cont.Start
HS/CS
VS
BNC
Connector
BNC/D-SUB
MultiSync
EXIT
PROCEED
RESET
BNC/D-SUB
Figure E.1
4
6
FP Series monitor and the other
®
Figure B.2
Power Outlet
Power
Cord
Figure D.1
95/98 INF file for your MultiSync FP
®
Power Button
12/3/98, 4:10 PM