Wet Shave; Trimmer; 3-Day Beard Attachment; Cleaning And Maintenance - Silvercrest SFR 1200 A1 Operation And Safety Notes

Before first use / Cleaning and maintenance

Wet shave

U se a fine-bubbled shaving foam.
CAUTION! We advise against the use of
shaving gel, as it can stick the foil
cutter set together.
12
A pply a thin layer of shaving foam to your
face. Shaving foam is the most suitable choice
from the wide range of available cosmetic
shaving products. Do not use a thick layer of
shaving foam, as this can detrimentally affect
the performance of the shaver.
P roceed with the shave in all other respects as
described in the section "Foil shave".
I f the shaving head
the shaver under running water (refer to the
section "Wet cleaning").

Trimmer

The trimmer on the back of the device can be
1
switched on by pushing it out into the locked position.
Slide the trimmer towards the shaving head
far as it will go.
It can be used for shortening longer beard hair,
trimming contours, sideburns and walrus moustaches.
A fter use, slide the trimmer
position.

3-day beard attachment

The supplied protective cap
3-day beard attachment. Regular use of this attach-
ment allows you to create the effect of a three day
beard.
Note: Please note that using the 3-day beard at-
tachment produces a shave corresponding to anything
between a 3-day and a 7-day beard, depending
on the rate of growth of your beard.
P lace the protective cap
head and ensure it engages. The trimmer
9
is now blocked by the protective cap
40 GB/MT
and the
4
becomes blocked, rinse
9
as
9
back into its initial
1
can be used as a
2
on to the shaving
2
.
2
T o switch on the device, slide the ON / OFF
switch upwards. You can now trim your beard.
7
T o switch off the device, slide the ON / OFF
switch downwards.
7
Note: When you are using the protective
cap as a 3-day beard attachment, the direct
2
contact of the foil with your skin is lost. The nat-
ural lubrication of the cutting system by the secre-
tions from your skin no longer takes place. After
each use of the 3-day beard attachment, spread
a drop of cutter or sewing machine oil on the
foil after cleaning. This will preserve the excellent
shaving performance of your shaver.
T ake off the protective cap
have a "1-day shave" without using the 3-day
beard attachment, or if you wish to use the
trimmer . Detach the protective cap
1
the shaving head

Cleaning and maintenance

Cleaning

C AUTION! RISK Of ELECTRIC SHOCK!
Always disconnect the shaver from the mains
supply and the flex before cleaning it. Do not
immerse into water or other fluids!
A lways clean the razor after each use in order
to ensure it works well.
W hen cleaning the appliance regularly with warm
water, occasionally moisten the long hair trim-
mer and cutter set
1
oil.
Dry cleaning:
C AUTION! Do not clean the foil with the brush
as this could damage it. Do not remove the foil!
P ress the release buttons
pull the shaving foil frame
K nock the shaving foil frame
surface.
B rush the cutter set
1
if you wish to
2
2
to do this.
9
with sewing machine
12
on the side and
5
out or blow it out.
3
out on an even
3
with the cleaning brush.
12
from