Creative Shareme Connection; Voice Command And Indicators; Clear Or Reset Headset; Automatic Shutdown - Creative AURVANA Gold Quick Start Manual

headset to connect both in Multipoint.
Creative ShareMe™ connection
•
The Creative Aurvana Gold allows you to share your entertainment with another person wearing
another set of Creative Aurvana Gold or Creative wireless headset featuring Creative ShareMe™
connectivity.
• Before enabling Creative ShareMe connection, pause your music playback and disengage any voice
call on your mobile device.
•
Place the two headsets to be paired close together and power them on.
•
Simultaneously press the Volume Up "+" and Volume Down "-" buttons (Set A) on the fi rst headset until
the indicator turns Green and blinks rapidly; and simultaneously press the "Next" and "Previous"
buttons (Set B) on the second headset until the indicator turns Green and blinks rapidly.
•
Note that if the fi rst headset to be paired is using Set A buttons, then the second headset will need to
use Set B buttons; or vice versa.
•
Once the two headsets are paired, their indicators will blink in a combination of blue and green colors.
•
To conserve battery life, ShareMe connection will end in 15 minutes if no audio is streamed from the
device.
•
Note that in Creative ShareMe connection, the paired headset is considered as one of the Multipoint device.

Voice command and indicators

•
The Creative Aurvana Gold provides audible indicators on headset connectivity or battery level
status. Press the Multifunction button twice to fi nd out the battery level status (except during voice
calls).
• Note that this is currently available in English only. Press and release Multifunction and Volume Down
"-" buttons to disable. Press and release Multifunction and Volume Up "+" buttons to enable.
•
The headset battery level indicator will be displayed on an iPhone
connected (device dependent).

Clear or reset headset

•
Press and hold the Volume Down "-" and Multifunction buttons for more than 6 seconds to clear the
paired Bluetooth devices
•
If the headset malfunctions, reset it by supplying USB power, then press the Volume Up "+" and
Multifunction buttons for about 1 second

Automatic shutdown

•
Once the headset is powered on, if it is unable to connect to the last paired device or failed to pair with
a new device within 5 minutes, the headset will automatically shut down.
List of button, indicator and connector / port functions
® or iPad ® once paired and
Button
1.
Power: Press and hold for 2 seconds to power on the headset.
Multifunction (Power / Pair /
Press and hold for 3 seconds to power off the headset.
Call and Play / Pause)
Pair: In off mode, press and hold for more than 5 seconds to
activate Pairing mode.
Call: Press and hold for 1 second to activate voice dial. Press
and release to answer or end an incoming call. Press and hold
for 2 seconds to reject a call during an incoming call. Press twice
to accept a call waiting and put on hold the ongoing call. Press
together with '+' button and release to initiate a three-way call.
Music playback: Press to play. Press again to pause playback
2.
Next, Forward / Previous, Press to change to the next or previous track. Press and hold to
Backward scroll forward or backward a track (device dependent).
/
3.
Press '+' to increase or press '-' to decrease volume. A beep tone is
Volume Up / Volume Down
emitted at maximum volume level. Press and release both '+' and
/
'-' to mute or unmute the microphone during a call. (not available
in ShareMe).
4. Slide towards (l) to turn on Active Noise Cancellation to reduce
hearing unwanted external noises. Slide towards (o) to turn it off.
Light Indicator
5.
Right earcup indicator Green and blinks slowly: ready to connect a device.
Green and blinks rapidly: attempts to connect to a Creative
ShareMe headset.
Blue and blinks slowly: connected to a paired device.
Blue and blinks rapidly: in pairing mode and is ready to pair
with a new device.
Function
Function