Makita RBC420 Original Instruction Manual page 20

4. Wind the lines up firmly to the direction shown by left-hand (LH) arrow on the
flange. Do not cross the lines.
5. Wind all but about 100 mm of the cords, leaving the ends temporarily hooked
through a notch on the side of the spool.
6. Put tap knob onto the housing hub, positioning it can freely move up and down
against spring tension. Put the spool into the housing, aligning the teeth on
spool and tap knob alternately like gears.
7. Put in the cutting lines through the slot of eyelets.
8. Put the cover onto the housing, aligning the tabs on cover and the windows on
housing. Make sure the cover is secured exactly to the housing. Outer edge of
cover locking tab and outer surface of the housing should be on same
circumference.
to "LH" direction
Outer Edge of
Cover Locking Tab
20
Wind tightly
100 – 150 mm
from notches
Tab knob's Teeth
Spool's Teeth
Cover Locking Tab
Housing Window
Outer surface of
Housing