Powerboost Function; Usage Restrictions; To Turn On; To Deactivate - Bosch PIE375C14E Instruction Manual

Powerboost function

The Powerboost function can be used to heat large amounts of
water more quickly than the power level

Usage restrictions

This function is always available for all hotplates, provided the
other hotplate in the same group is not in use (see illustration).
If you want to activate this function for hotplate 1, for example,
hotplate 2 must then be switched off, and vice-versa.
Otherwise, the letter and the heat setting flash alternately in
›
the display. The previously selected heat setting is then
automatically set.

Automatic time limitation

If the hotplate is used for prolonged periods and the settings
are not adjusted, the automatic time limitation function is
activated.
The hotplate stops heating. The
heat indicator / flash alternatively in the display.
• œ

Deactivating the warning signal

A short beep sounds to confirm that a symbol has been
touched. Depending on the model, this signal can be switched
off.
Set the hotplates to the power level
1.
Switch the hotplates off individually, starting with the hotplate
2.
which is controlled by the knob on the right-hand side of the
control panel.

Care and cleaning

The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition

Hob

Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cool enough
before attempting to clean it.
Only use cleaning products specifically designed for hobs.
Follow the instructions provided on the packaging.
Do not use:
Undiluted washing-up liquid
■
Dishwasher detergent
■
Abrasive products
■
Š .
, symbol and the residual
" ‰ ‹
.
„

To turn on:

Select the required power level.
1.
Press the boost symbol of the selected hotplate. The
G
2.
indicator lights up. The function has been turned on.

To deactivate

Press the boost symbol. The display
G
function will be deactivated.
Note: In certain circumstances, the Powerboost function may
turn off automatically in order to protect the electronic
components inside the hob.
When the control is turned to setting 0, the indicator goes off.
The hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
Press the boost symbol of the left hotplate for at least 5
G
3.
seconds. After 5 seconds has elapsed a beep will sound to
confirm this.
The warning signal can be reactivated. To do this, follow the
same procedure as for deactivating the warning signal.
Corrosive products such as oven sprays or stain removers
■
Sponges that may scratch
■
High-pressure or steam cleaners
■
The best way to remove stubborn stains is to use a glass
scraper. Follow the manufacturer's instructions.
Suitable glass scrapers can be obtained through the Technical
Assistance Service or from our online shop.

Hob frame

In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
■
›
goes out. The
›
9