Router Safety Warnings - Makita RF1100 Instruction Manual

Fig. A
Grounding
Blade
000088

ROUTER SAFETY WARNINGS

1. Use clamps or another practical way to secure
and support the workpiece to a stable
platform. Holding the work by your hand or
against the body leaves it unstable and may lead
to loss of control.
2. Wear hearing protection during extended
period of operation.
3. Handle the bits very carefully.
4. Check the bit carefully for cracks or damage
before operation.
damaged bit immediately.
5. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
6. Hold the tool firmly with both hands.
7. Keep hands away from rotating parts.
8. Make sure the bit is not contacting the
workpiece before the switch is turned on.
9. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could
installed bit.
10. Be careful of the bit rotating direction and the
feed direction.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Always switch off and wait for the bit to come
to a complete stop before removing the tool
from workpiece.
13. Do not touch the bit immediately after
operation; it may be extremely hot and could
burn your skin.
14. Do not smear the tool base carelessly with
thinner, gasoline, oil or the like. They may
cause cracks in the tool base.
15. Use bits of the correct shank diameter
suitable for the speed of the tool.
16. Some material contains chemicals which may
be toxic. Take caution to prevent dust
Cover of Grounded
Outlet Box
GEB105-1
Replace cracked
indicate improperly
inhalation and skin contact. Follow material
supplier safety data.
17. Always use the correct dust mask/respirator
for the material and application you are
working with.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
･
･
･
or
･
･
4
volts
amperes
hertz
alternating current
no load speed
revolutions or reciprocation per minute
USD101-2