Fitting The Blade Guard/Combination Guard, Grass Blade And Grass Cutter; Fitting Other Guards And Cutting Attachments; Fitting The Trimmer Guard And Trimmer Head - Jonsered GT2125 Operator's Manual

Fitting the blade guard/combination
guard, grass blade and grass cutter
(GC 2125, GC 2125C)
• Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt. CAUTION!
Use the recommended blade guard. See the Technical
data section.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
• Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (Caution!
left-hand thread).
WARNING! Grass blades or grass knives
!
may only be used when the J-handle is
fitted. Clearing blades must never be used
with the J-handle.
ASSEMBLY
Fitting other guards and cutting
attachments
(GC 2125, GC 2125C)
•
G
F
E
D
B
A C
•
•
•
•
•
Fitting the trimmer guard and
trimmer head
(GT 2125)
Guard
•
Trimmer head
•
•
•
Fit the correct trimmer guard (A) for use with the trimmer
head. Hook the trimmer guard/combination guard onto
the fitting on the shaft and secure with the bolt (L).
Fit the drive disc (B) on the output shaft.
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
H
To dismantle, follow the instructions in the reverse order.
Fit the guard as shown in the diagram. Tighten securely.
Fit the dust cup on the shaft. The nut must be completely
covered by the dust cup.
Hold the dust cup with a spanner to prevent the shaft from
rotating.
Screw the trimmer head onto the shaft.
– 13
English