Buffalo hd-patu3 User Manual page 9

13
Formatting will begin. Progress is displayed as a percentage.
To abort the format, right-click the partition and click [Cancel Format].
Memo
14
If the message "The request cannot be completed because the volume is open or
in use" is displayed:
The partition was created, but the format didn't complete. Click [OK] to format the created
partition as described below.
1
Right-click the created partition and select [Format].
2
If necessary, set the volume label and file system, and click [OK].
Note: If [Perform a quick format] is checked, the format will be completed much
quicker.
3
After this, follow the on-screen messages.
This completes the formatting process.
Note: To divide the drive into multiple partitions, repeat steps 10-14 for each partition.
Click [Finish].
If the formatting process was completed
normally, [Healthy] is displayed in
addition to the volume label and
partition.
HD-PATU3 User Manual
9