Hardware Installation - D-Link DGE-560SX Quick Installation Manual

Gigabit ethernet 1000base-sx(lc) pci-express x4 adapter

Hide thumbs Also See for DGE-560SX:

Hardware Installation

Before you start, make sure to turn off your computer and unplug the

power cord.

Caution: To avoid damage caused by static electricity, make sure to properly

ground yourself by first touching a metal part of your computer to discharge any

static electricity before working with the DGE-560SX Ethernet Adapter.

1. Shut down the computer and unplug the power cord.

2. Remove the chassis cover.

3. Insert the card into an empty PCI-Express slot.

4. Replace the computer chassis cover.

5. Reconnect the power cord and turn the computer on. If the BIOS section of

your computer is plug and play compliant, then at the power up the BIOS will

automatically recognize and configure any newly installed DGE–560SX

Adapter.

Installing the DGE-560SX Driver

1. Turn on the computer.

2. Insert the driver CD included with the DGE–560SX into the CD ROM.

3. For Windows OS, the screen shown below will appear automatically. Click

Install Driver and follow the instructions on the installation wizard. The

following drivers are supported:

Table of Contents