Asus P8P67-M User Manual page 38

3. IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are
three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
P8P67-M IDE connector
If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the
same setting.
4. LPT connector (26-1 pin LPT)
The LPT (Line Printing Terminal) connector supports devices such as a printer. LPT is
standardized as IEEE 1284, which is the parallel port interface on IBM PC-compatible
computers.
P8P67-M LPT connector
ASUS P8P67-M
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
cable connector. This prevents incorrect insertion when you connect the IDE cable.
P8P67-M
P8P67-M
Mode of device(s)
-
Master
Slave
Master
Slave
PRI_EIDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
LPT
Cable connector
Black
Black
Gray
Black or gray
1-26