stabo multifon security IV User Manual page 38

Updating the firmware via Internet
If the monitor is connected to the Internet and a new
firmware is available, the display shows the
load symbol.
Open the menu item Firmware Upgrade using the OK
key. Use the key to select From Server.
Use the key to select Yes and confirm by pressing
OK.
The new firmware is installed.
After having installed the firmware, the monitor is
restarted automatically, afterwards the installation is
finished.
Notes: During installation, both the Internet connection
and the power supply must not be interrupted!
After having installed a new firmware, all personal
settings are lost and the system is reset to default
settings!
Format Memory
Open this menu item using the OK key to format your
SD memory card prior to first usage.
Important note: Please note that all stored data will
be deleted when formatting a data carrier which was
already in use!
Use the key to select Yes and confirm by pressing
OK.
The following is shown: Are you sure you want to delete
all stored files?
Use the key to select Yes – or cancel formatting by selecting No – and confirm by pressing
OK.
After formatting has been completed, Format OK is shown.
Network
3 submenus are available here:
Network Setting: Network settings
Note: Ensure that any setting/modification is done by
a qualified person only!
Information: Information on network settings
Reset Password: For resetting the password to default
setting (000000)
Down-
38