Appendix; Troubleshooting; Error Message - Korg electribe Owner's Manual

Appendix

1. Troubleshooting

The display won't turn on.
□ Have you securely connected the AC adapter?
□ Have you connected the AC adapter to the power outlet?
□ Do you have enough battery charge?
There is no sound!
□ Have you correctly connected the amplifier, mixer or head-
phones to the jack?
□ Have you turned the power on for the amplifier or mixer and
set them correctly?
□ Have you set the Volume knob of the electribe to an appropri-
ate level?
Playback won't stop!
□ A Pattern keeps playing back, repeating the selected pattern.
Press the Stop button after playback ends.
The sounds / motion sequence actions have changed
from what I created during editing!
□ Have you completed the write operation after editing?
→ After you have edited, write the data to memory before
switching the pattern in each mode or before you turn off the
power.
I can't control MIDI!
□ Have you correctly connected the MIDI cable?
If you play this system from an external device:
□ Have you correctly set the MIDI channel in global mode? (→
p.14)
If you play an external device from this system:
□ Have you set the same MIDI channel for the receiving device
and for this system?
I don't hear anything when I'm playing on the trigger
pad.
□ Have you saved the part after editing? (→ p.12)
□ Have you turned the Keyboard button ON?
□ Have you disabled the motion sequence? (→ p.12)
I can't seem to use my memory card.
□ Have you formatted the memory card only in your electribe?
→ You need to re-format any memory card that has been format-
ted by a computer or digital camera with this system before it
can use it. (→ p.14)
□ Have you correctly inserted the memory card?
→ Remove and insert the memory card again. (→ p.8)
□ Is the card size supported by this system?
→ This system supports SD cards from 512MB to 2GB, and SDHC
cards of 32GB or less.
16

2. Error message

Pressing the Exit button will close the message window.
Card Error
Memory card is damaged.
→ Make a backup of all files in the memory card.
→ Make a backup of all data in your memory card to a computer,
etc. and then format the memory card with this system. Upon
completion, you can replace all of your data to the newly
formatted memory card.
Protected
Data protection is turned ON when you save data to a memory
card.
→ If the write protect switch on the memory card is locked,
unlock it.
Card Full
The memory card does not have sufficient available space.
→ Delete file(s) on the memory card to secure clear sufficient
space and then write or save your data again.
Event Over
The number of events exceeds the maximum number of events
that can be recorded.
File Error
File can't be read/write correctly.
Memory Full
This system does not have sufficient memory capacity when you
load data from a memory card or copy data to this system.
→ Erase unnecessary data to increase the amount of available
space.
Motion Seq Full
Motion sequence cannot be recorded.
→ The Electribe can support up to 24 motion sequence patterns.
Erase any unnecessary motions and try to add your motion
sequence again.