Related Manuals for Conceptronic CM3G
Summary of Contents for Conceptronic CM3G
- Page 1 CM3G-CM3GP-CM3GPP Media Giant How to… Record from a embedded DVB-T TV tuner with the Conceptronic CM3G/P/PP ® Copyright 2007 by Conceptronic – All rights reserved www.conceptronic.net Page 1 of 7...
- Page 2 CM3G/P/PP record digital channels. It is mandatory that your TV has some kind of video output to let the CM3G/P/PP record digital channels. It could be that the video output from the TV only allows an analog tuner signal instead of DVB-T. Then please check with the TVs manufacturer to do a correct configuration.
- Page 3 Be sure that the RCA to SCART adaptor is set in OUTPUT mode. Step 2: Connecting Conceptronic CM3G/P/PP to TV Refer to chapter six (“Connecting your Media Giant”) of the CM3G/P/PP manual on how to connect the CM3G/P/PP to your TV.
- Page 4 Step 3: Recording from TVDVB-T When all cable connections have been made turn on your CM3G/P/PP and your TVDVB-T. The menu of the CM3G/P/PP will be shown on your TV. If this is not the case, refer to chapter seven (“First-Time Configuration”) of the CM3G/P/PP manual.
- Page 5 Scheduled recording You can set a scheduled recording to let the CM3G/P/PP start recording at a specified date/time. 1. Select “Scheduled recording” at the initial menu. The following image will be shown on your screen: The Scheduled Recording menu shows 5 options, which can be selected with the left and right navigation buttons (8) of the remote control: Add: Add a new scheduled recording.
- Page 6 ‘Standby’. Make sure the TVDVB-T is set to the right channel for the recording and leave it turned on. ® Copyright 2007 by Conceptronic – All rights reserved www.conceptronic.net Page 6 of 7...
- Page 7 Note: Do not use the switch on the back of the CM3G/P/PP to turn off the device, since it will not be able to turn on itself when a recording needs to be started. The device always needs to be in stand-by mode when a recording is scheduled.
Need help?
Do you have a question about the CM3G and is the answer not in the manual?
Questions and answers