Operate Internet Radio (Fm/Alarm/Sleep/Error); Audio Settings - VIETA VH-HA042 User Manual

Now playing information
While a track is playing, the screen shows its track
name (UPnP). There is also a progress bar with figures
for elapsed and total track time. At the bottom of
the screen, an icon indicates UPnP. To view further
information, press Info.
Each time you press Info, another set of information is
displayed, cycling through the following:
• Artist, album, codec/sampling rate, playback buffer
FM radio mode
FM radio mode receives analogue radio from the
FM band and displays RDS (Radio Data System)
information about the station and show (where
broadcast).
To enter FM mode, either press Mode until the display
shows FM Radio or select Menu > Main menu > FM.
Selecting stations
To find a station, press Select . The frequency display
starts to run up as VH-HA042 scans the FM band.
Alternatively, you can scan up or down by pressing
and holding the >> or << buttons or tune manually with
quick presses, or by turning the Select control.
Presets
To store an FM preset, press and hold Preset until the
display shows the Save preset screen. Select one of
the 10 presets to save the currently playing station.
To select a preset, press Preset briefly, then select one
of the listed preset stations. When a preset station.
Operate Internet Radio
(FM/Alarm/Sleep/Error)
Now playing information
While an FM station is playing, the screen shows one of
the two following sets data:
• If RDS information is available, by default the service
name (i.e. station name) is displayed. You can cycle
through further RDS information by pressing Info .
Each time you press Info , another set of information
is displayed, cycling through RDS radio text, RDS
programme type, frequency and today's date.
• If no RDS information is available, the currently tuned
frequency is shown.
Scan settings
By default, FM scans stop at any available station. This
may result in a poor signal-to-noise ratio (hiss) from
weak stations. To change the scan settings to stop only
at stations with good signal strength, select Menu >
Scan setting > Strong stations only? > Yes.

Audio settings

By default, all stereo stations are reproduced in stereo.
For weak stations, this may result in a poor signal-to-
noise ratio (hiss). To play weak stations in mono, select
Menu > Audio setting > FM weak reception: Listen in
mono only > Yes.
Alarms and sleep
As well as a clock/calendar, there are two versatile
wake-up alarms with snooze facility, and a sleep
function to turn the system off after a set period. Each
alarm can be set to start in a particular mode.
To set the clock/calendar,Bookmark not defined.
Alarmas
To set or change an alarm, either press Alarm or select
Menu > Main menu > Alarms.
Select the alarm number (1 or 2) then configure the
following parameters:
• Enable: on/off,
• Frequency: Daily, Once, Weekends or Weekdays,
• Time,
• Mode: Buzzer, Internet radio or FM,
• Preset: Last listened or 1-10,
• Volume: 0 – 20.
53