Table of Contents
Advertisement
Chapter 1
Introduction
What You Need to Get Started
Software Programming Choices
National Instruments Application Software
PCI-6110E/6111E User Manual
and a ribbon cable to route timing and trigger signals between several
functions on as many as five DAQ boards in your computer.
Detailed specifications of the 611X E board are in Appendix A,
Specifications.
To set up and use the 611X E board, you will need the following:
Either the PCI-6110E or PCI-6111E board
PCI-6110E/6111E User Manual
One of the following software packages and documentation:
ComponentWorks
LabVIEW for Macintosh
LabVIEW for Windows
LabWindows/CVI for Windows
Measure
NI-DAQ for PC Compatibles
VirtualBench
Your computer
You have several options to choose from when programming your
National Instruments DAQ and SCXI hardware. You can use National
Instruments application software, NI-DAQ, or register-level
programming.
ComponentWorks contains tools for data acquisition and instrument
control built on NI-DAQ driver software. ComponentWorks provides
a higher-level programming interface for building virtual instruments
through standard OLE controls and DLLs. With ComponentWorks, you
can use all of the configuration tools, resource management utilities,
and interactive control utilities included with NI-DAQ.
LabVIEW features interactive graphics, a state-of-the-art user
interface, and a powerful graphical programming language. The
1-2
© National Instruments Corporation
Advertisement
Table of Contents
