Advertisement
Connectivity Options
Accessing the signals on the I/O connectors requires at least one cable and one signal accessory. Table 1
summarizes the National Instruments connectivity options available for use with the NI 78xxR device.
Cable
*
SHC68-68-RMIO
(NI Recommended)
SHC68-68-RDIO
(NI Recommended)
SH68-C68-S
CAT 5 Ethernet
*
crossover cable
*
NI 78xxR Multifunction R Series devices only.
†
For a diagram of the twisted pairs in the SHC68-68-RMIO and SHC68-68-RDIO cables and the signals to which they
correspond, go to
ni.com/info
Getting Started with R Series Intelligent DAQ
Table 1. R Series Connectivity Options
Connector
Accessory
0
NI SCB-68
1, 2
NI SCB-68
1, 2
NI cRIO-9151
R Series Expansion
chassis
0, 1, 2
NI SCB-68
—
—
and enter the info code
High-performance shielded cable wired
specifically for signal connection from the
RMIO connector
to provide higher signal integrity and noise
immunity.
High-performance shielded cable wired
specifically for signal connection from the
RDIO connector
to provide higher signal integrity and noise
immunity.
Connect signals from the RDIO connector to the
NI cRIO-9151 Expansion chassis for expansion
I/O and signal conditioning.
Basic shielded cable for signal connection from
the RMIO or RDIO connector to the NI SCB-68
terminal block for noise reduction.
For use with the NI PXI-78xxR running the
LabVIEW Real-Time Module, if the real-time
PXI system is not configured on a network.
To connect the PXI system to a network port, use
a standard CAT 5 10/100Base-T Ethernet cable.
.
rdrmio
6
Description
†
to the SCB-68 terminal block
†
to the SCB-68 terminal block
ni.com
Advertisement
