General Options; Display Settings; Energy Saving - PURE EVOKE-2S Owner's Manual

General options

Display settings

You can adjust the brightness and time-out duration of the display for when the unit is switched
on and in standby. To change display options:
1. Press Menu, scroll to 'Display settings' and push the Tune dial.
2. Now choose either 'Active' to change settings that apply when the unit is switched on, or
'Standby' to change settings that apply in standby.
Changing the display time-out duration
Select 'Duration' and choose from the following two modes:
Always on
Timed off
Changing your preferred brightness level
Select 'Brightness' and choose from the following options:
Automatic
1–10
Set clock
You can manually set the time and date if required. If you have a DAB signal and/or a good FM
(RDS) reception these will be updated automatically.

Energy saving

EVOKE-2S is part of the PURE EcoPlus product family, designed and manufactured to minimise
power consumption when the unit is switched on and to use less than 1 Watt in standby. One way
this low power consumption is enabled is by not collecting and storing Intellitext messages when
the unit is in standby. You can override this option by switching off energy saving mode, but this
will increase standby power consumption. Two options are available:
On
Off
Note: if you fi t the optional ChargePAK E1 the unit will switch off when you press the Standby
button and not enter standby, as long as the unit is not connected to mains power.
Setup options
12
The screen is always set to your preferred brightness level.
The screen is set to your preferred brightness level when a button is pressed and
then switches off after 7 seconds of inactivity.
The brightness of the screen adjusts automatically depending on the ambient light
levels in the room (default).
Turn the Tune dial to vary the brightness level between 1 (very dim) and 10 (very
bright) and push to confi rm your preferred setting.
EVOKE-2S updates the Intellitext data when you tune to a station that broadcasts
Intellitext. Intellitext data is not collected in standby.
EVOKE-2S collects Intellitext data in standby from the last station you tuned to
with Intellitext, which increases standby power consumption.