Makita 6723DW Instruction Manual page 7

Reverse
(Removing screws)
6
2. To rotate the bit holder in a reverse (removing screws) direction, press the left hand side of the On/Off switch marked
. See figure 6.
3. Release the On/Off switch to stop the screwdriver.
NOTE:
Always use sharp good quality screwdriver bits. The performance and safety of the screwdriver is dependant on the
quality of the bits used.
4. Using the LED light
7
5. Using the folding handle
8
Press
The screwdriver is equipped with an LED light to assist when
operating the screwdriver in dark recesses or other poorly lit
areas. To switch the LED light On, press the LED light On/Off
switch as shown in figure 7.
To switch the LED light Off press the LED light On/Off switch
again.
The screwdriver is equipped with a folding handle for either in-
line, or pistol grip use. When folded into the pistol grip position it
gives assistance when used in areas that may have restricted
access. See figure 8.
To use the folding handle, grip the lower handle with one hand
and move the upper handle to the desired position with the other
hand.
7