Camera Access Point Connection - Canon WFT-E6 Operational Manual

Camera Access Point Connection

When the camera is set to
Access Point connection. Initially, basic default network settings (SSID, password, etc.) are
saved in the camera and you can use these settings to immediately connect a device to the
camera.
If you prefer to use different settings, follow the procedure below.
mode, connect a Wi-Fi enabled device using a Camera
1
Set the camera to
the [Connection Settings] submenu.
[w System Setup] > [Network Settings] >
[Connection Settings]
The current Camera Access Point connection
settings will be displayed on the screen. To change
the settings, press SET. To keep the current
settings, press the CANCEL button.
2
To change the [SSID] (network name),
select [Input] and then press SET.
Enter the SSID (network name) the camera will
use as a Wi-Fi access point using the keyboard
screen (A 10).
The network name is needed to connect the Wi-Fi
enabled device to the camera. If necessary, write it
down.
3
Select the wireless connection mode
(5 GHz band or 2.4 GHz band) and then
press SET.
4
Select the channel and then press SET.
Available channels will differ depending on the
wireless connection mode selected in the previous
step.
5
Select the encryption method and then
press SET.
If you selected [Open/No encryption], continue
with the procedure to configure the IP address
assignment (A 16). If you selected [WPA2-PSK/
AES], continue the procedure to set the password.
mode and open
9