Replacement Of Lamp - Samsung CM1629 Service Manual

4-7 Replacement of Fan Motor
1. Remove the outer panel and back-cover.
2. Discharge the high voltage capacitor.
3. Remove all the lead wires from Magnetron and High
Voltage Capacitor.
4. Remove 2 screws securing the duct fan.
5. Remove 2 screws securing the Supporter- Fan Mount.
6. Lift the Ventilation Motor Ass'y slightly left upward and
pull it out.
7. Remove lead wires and connectors.
8. Remove a screw securing the C-Film to the Supporter-
Fan-Mount.
9. Turn the fan motor ass'y over so that the bracket side
is up.
10. Remove 2 screws securing the Ventilation Motor.
4-8 Replacement of Tray
1. Open the door.
2. Remove the tray by inserting a thin metal tool into
the gap between the oven wall and the tray silicon
cover.
3. Insert the new tray by tilting it across the oven
cavity.
4. Firstly fix the front part (refers to the place where
the silicon cover is thinner than the other 3 edges)
and then place the backward part carefully and
firmly.
NOTE : Be careful when you handle the tray since it
is fragile.

4-9 Replacement of Lamp

NOTE : You don't need to remove the outer panel or
other parts in order to replace a lamp.
1. Remove a screw securing the lamp cover.
2. Remove the lamp by rotating it clockwise.
3. Replace with a new lamp by rotating it counter-
clockwise.
NOTE : If it is necessary to replace the lamp holder,
you can disconnect lead wires by pushing
down on the hole of lead wires using a long
pointed tool.
Tray
Lamp Cover
Outer Panel
- 15 -
Ventilation Motor
C-Film
Supporter-Fan-Mount
Duct-Fan
Lamp Holder