Dometic Origo - Dometic ORIGO 1500 Operating Manual

_Origo_1500_3000_6000.book Seite 16 Freitag, 29. Januar 2010 4:09 16
Mounting the stove
7.3 Installing Origo 6000 and 6200 (fig. 6, page 4)
Caution – Danger of damaging the device!
a
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
Determine the best position for the pivot points by placing the range in the
desired position.
Open the stovetop.
Mark the fixing points through the holes in the gimbal sideplates (1).
Remove the range.
Fasten the gimbal arms (2) with fibre washers and screws removed.
Fit one fibre washer with round hole (3) on each gimbal arm (2).
Lift the range in-between gimbal arms (2) so that the gimbal sideplates will
spring into place on the gimbal arms (2).
With open stovetop fit the fibre washers with oblong holes (4) to the
gimbal arm (2).
Ensure they fit properly on the gimbal arms (2) so they can't rotate.
Fit steel washers (5), screws (6) and tighten.
Adjust the tension of the screws to desired friction.
Place a class B-1 fire extinguisher in reaching distance.
7.4 Installing Origo 6100
Caution – Danger of damaging the device!
a
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
Make a cutout with the following dimensions (W x H x D):
490 x 530 x 400 mm.
Place the oven into the cutout.
Fix the oven.
Place a class B-1 fire extinguisher in reaching distance.
16

Dometic ORIGO